LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System (Service Information) >> Airbag Module Disposal (Deployment Processing On Vehicle) >> Procedure >> Seat Cushion Airbag Module

Seat Cushion Airbag Module

  1. Turn the ignition switch to OFF.
  2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>NOTE>SAFETY .
  3. Remove the bolts that secure the passenger's seat.
    NOTE: For models with power seat, remove the slide rail installing bolt before disconnecting the ground terminal from the battery sensor.
  4. Disconnect the seat cushion airbag module connector under the front seat cushion.
  5. Short the terminal to the alligator clip furnished as airbag deployment tool.
    CAUTION: Terminals of airbag deployment tool should be kept shorted until just before activation of airbag module.

    Preparation tool:  ST: AIRBAG DEPLOYMENT TOOL (98299PA030)

  6. Connect airbag deployment tool (A) and test harness adapter AU (B).

    Preparation tool:  ST: TEST HARNESS ADAPTER AU (98299AL000)

    G13622738Courtesy of SUBARU OF AMERICA, INC.
  7. Connect the test harness adapter AU to the seat cushion airbag module connector (yellow).
    CAUTION: Do not place any object on front seat.
  8. Tighten the passenger's seat to the specified torque.

    Tightening torque:  Front seat assembly: 53 N.m (5.4 kgf-m, 39.1 ft-lb)

  9. Make sure there is no one inside the vehicle.
  10. Extend the wiring of airbag deployment tool to the limit, and close all the windows and sunroof completely.
    G10270499Courtesy of SUBARU OF AMERICA, INC.
  11. Move the battery at least 5 m (16 ft) from the vehicle, and confirm safety in the area.
  12. Connect the airbag deployment tool alligator clip to the battery negative (-) terminal.
  13. Connect the other cable of airbag deployment tool to the battery positive (+) terminal, and activate the airbag module.
    CAUTION:
    • After activation, the airbag module will be extremely hot. Let it cool down for at least 40 minutes in an area with no one around.
    • Do not expose the activated airbag module to water.
    G10270500Courtesy of SUBARU OF AMERICA, INC.
  14. Remove the seat cushion airbag module. Refer to AIRBAG SYSTEM>Seat Cushion Airbag Module>REMOVAL .
  15. Place the activated airbag module in a sealed vinyl bag, then discard.
    G10277019Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals