LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System (Service Information) >> Airbag Control Module >> Removal

Airbag Control Module: Removal

CAUTION:
  • Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION .
  • Do not disassemble the airbag control module.
  • If the airbag control module is deformed or if there is any trace of water on the module, replace the airbag control module with a new one.
  • Do not drop the airbag control module.
  • After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
  1. Turn the ignition switch to OFF.

    Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>NOTE>BATTERY .

    NOTE: Release the shift lock and shift the select lever to the "N" position. Refer to CONTROL SYSTEMS>Select Lever>REMOVAL .
  2. Remove the cover assembly front and the console box assembly. Refer to EXTERIOR/INTERIOR TRIM>Console Box>REMOVAL .
  3. Remove the ornament panel mid passenger and the center information display assembly. Refer to ENTERTAINMENT & MONITORING>Cockpit Display>REMOVAL>DISPLAY ASSEMBLY .
  4. Remove the cover center side and the tray center LWR on the left and right sides. Refer to EXTERIOR/INTERIOR TRIM>Center Console>REMOVAL .
  5. Remove the clips, and remove the duct console center and the duct console front.
    G13622588Courtesy of SUBARU OF AMERICA, INC.
    G13622589Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the airbag control module.
    1. Disconnect the connector from airbag control module. Refer to AIRBAG SYSTEM>Airbag Connector>PROCEDURE>AIRBAG CONTROL MODULE .
    2. Remove the bolt and nuts and remove the airbag control module.
    G13622692Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals