LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System (Service Information) >> Airbag Control Module >> Installation

Airbag Control Module: Installation

CAUTION: Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION .
  1. Before installation, inspect the following items and replace any faulty part with a new part.
    • Control module is deformed.
    • Control module connector is damaged.
  2. Install the airbag control module.
    CAUTION: Do not reuse the bolt and nut.
    Always replace with the specified new bolts and nuts.

    Tightening torque:  25 N.m (2.5 kgf-m, 18.4 ft-lb)

  3. Install the duct console front and the duct console center.
  4. Install the tray center LWR and the cover center side.
  5. Remove the center information display assembly and the ornament panel mid passenger.
  6. Install the cover assembly front and the console box assembly.

    Tightening torque:  Console box: 6.5 N.m (0.7 kgf-m, 4.8 ft-lb)

  7. Install the heater control assembly.
  8. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: After connecting the battery sensor terminal, place the select lever in the "P" position.
scientia non olet · About LEMON Manuals