LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (CVT Transaxle (Tr690) (Service Information)) >> Inhibitor Switch >> Removal

Inhibitor Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the mat center tray.
    G13620985Courtesy of SUBARU OF AMERICA, INC.
  3. Release the shift lock using a screwdriver, etc. and shift the select lever to the "N" range.
    G13621458Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the select cable from the transmission main body.
    CAUTION: Do not apply excessive load while holding the part (a).
    G13591814Courtesy of SUBARU OF AMERICA, INC.
    G13225470Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the spring pin (A) and remove the shifter arm (B).
    G13621942Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the connector and remove the inhibitor switch.
    G13225675Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals