LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (CVT Transaxle (Tr690) (Service Information)) >> Front Reduction Driven Gear >> Disassembly

Front Reduction Driven Gear: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front reduction driven shaft.
    G13622377Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the seal rings.
    G13622378Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the ball bearing.
    1. Tap the ball bearing outer race to remove through the hole of front reduction driven shaft using the round bar with diameter of 7 mm (0.28 in).
      NOTE: Remove by tapping the entire circumference equally.
      G13200370Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the snap ring, and then remove the retaining plate, drive plate, driven plate and dish plate.
    NOTE: In order to avoid installing the dish plate in the wrong direction, paint a mark before removal.
    G13622380Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals