LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Emission Control Systems (Aux. Emission Control Devices) (2.4L)) >> EGR Control Valve >> Removal

EGR Control Valve: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the intercooler. Refer to INTAKE (INDUCTION) (H4DOTC)>Intercooler>REMOVAL .
  3. Disconnect the connector (A).
  4. Remove the bolts securing the EGR control valve to the EGR cooler.
    G13198500Courtesy of SUBARU OF AMERICA, INC.
  5. Loosen the bolts (A) holding the EGR cooler.
  6. Remove the nuts securing the EGR control valve.
    G13198501Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the stud bolt using TORX® socket E8, and remove the EGR control valve.
    G13198502Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the gasket.
    G13198503Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals