LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical System (2.4L)) >> Rocker Cover >> Removal >> Rocker Cover RH

Rocker Cover RH

WARNING: This page is about a different variant/trim than selected.
NOTE: When replacing a single part, perform the work with the engine assembly installed to body.
  1. When working on the vehicle
    NOTE: When working on the vehicle, perform the following steps also.
    1. Remove the V-belt covers.
      G13619537Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the air cleaner case. Refer to INTAKE (INDUCTION) (H4DOTC)>Air Cleaner Case>REMOVAL .
  2. Remove the #1 ignition coil and the #3 ignition coil. Refer to IGNITION (H4DOTC)>Ignition Coil>REMOVAL>RH SIDE .
  3. Remove the clip from the oil pipe (vacuum pump).
    G13198819Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the clip holding the engine wiring harness from cam carrier RH.
    G13620232Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the rocker cover RH.
    G13620233Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the rocker cover gasket (ring type) and the spark plug pipe gasket, and remove the liquid gasket.
    CAUTION:
    • When removing the liquid gasket from engine unit using scraper, use special care not to damage the cam lobe of camshaft RH.
    • If the cam lobe of camshaft RH interferes, turn the crankshaft to the position where the scraper does not touch.
    G13620234Courtesy of SUBARU OF AMERICA, INC.
    G13620235Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the rocker cover gasket RH from the rocker cover RH, and remove the liquid gasket.
scientia non olet · About LEMON Manuals