LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Power Rear Gate System (Service Information) >> Power Rear Gate Touch Sensor >> Removal

Power Rear Gate Touch Sensor: Removal

  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the trim panel assembly rear gate. Refer to EXTERIOR/INTERIOR TRIM>Rear Gate Trim>REMOVAL .
  3. Remove the power rear gate touch sensor.
    1. Disconnect the connector.
    2. Release the clips, and then remove the power rear gate touch sensor.
      CAUTION:
      • Applying excessive force to the harness may damage the water shield. Always disconnect the connector first.
      • If the water shield has been broken, replace it together with the power rear gate touch sensor to avoid water leak.
      G13626195Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals