DTC B2790: Id Code Box Circuit

DTC detecting condition:

When EEPROM cannot be written in or readout response is absent.

Trouble symptom:

Engine will not start.

CAUTION:

For replacement procedure of ID code box, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.
Before performing diagnosis, refer to "CAUTION" in "General Description". Refer to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>General Description>CAUTION .

CHECK DTC .
1. Turn the ignition switch to OFF.
2. Using the Subaru Select Monitor, perform the clear memory of [Keyless Access with Push Button Start(Collation)]. Refer to COMMON (DIAG)>CLEAR MEMORY .
3. Turn the ignition switch to OFF → ON.
4. Register the ID code box. Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.
5. Read the DTC of [Keyless Access with Push Button Start(Collation)] using the Subaru Select Monitor. Refer to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC B2790 displayed? (Current malfunction)

Yes: Replace the ID code box. Refer to SECURITY AND LOCKS>ID CODE BOX .

No : ID code box registration was not performed properly.