Inspection Mode: Procedure

It is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded.

1. Turn the ignition switch to ON, and wait for 6 seconds or more. (*1)
2. Confirm that the RAB warning light (RAB malfunction indicator light) of MID in the combination meter is off.
3. Using the Subaru Select Monitor, read all DTCs to check that the DTC is not displayed. (*2) Refer to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .

*1: Even with normal condition, "RAB warning light (RAB OFF indicator light)" illuminates for 6 seconds after turning the ignition switch to ON, and then goes off after 6 seconds.

*2: Perform all DTC diagnosis within 3 seconds after the ignition switch is turned to ON. It is not necessary to shift the gear in the R range to operate the function.