Cancel Code: List
| Code | Description & trouble part | Contents |
|---|---|---|
| 0X02 | IGN Low Voltage | The ignition power supply of RAB Control Module is reduced.
NOTE:
This may temporarily occur due to battery voltage. If the cancel code persists, perform the diagnosis of the power supply system.
|
| 0X03 | RRC Sonar Noise | Sonar sensor (right inner) signal is interfered due to noise.
NOTE:
This may temporarily occur due to electronic components used inside/outside the vehicle. If the cancel code persists, perform the diagnosis of LAN system.
|
| 0X04 | RLC Sonar Noise | Sonar sensor (left inner) signal is interfered due to noise.
NOTE:
This may temporarily occur due to electronic components used inside/outside the vehicle. If the cancel code persists, perform the diagnosis of LAN system.
|
| 0X05 | RR Sonar Noise | Sonar sensor (right corner) signal is interfered due to noise.
NOTE:
This may temporarily occur due to electronic components used inside/outside the vehicle. If the cancel code persists, perform the diagnosis of LAN system.
|
| 0X06 | RL Sonar | Noise Sonar sensor (left corner) signal is interfered due to noise.
NOTE:
This may temporarily occur due to electronic components used inside/outside the vehicle. If the cancel code persists, perform the diagnosis of LAN system.
|
| 0X0B | RRC Sonar Dirty HALT II | Substance adhered to the sonar sensor (right inner).
NOTE:
If the sensor surface is covered with snow, ice, dirt, water or seal, or equipped with other parts, remove them. If the cancel code persists, replace the sonar sensor.
|
| 0X0C | RLC Sonar Dirty HALT II | Substance adhered to the sonar sensor (left inner).
NOTE:
If the sensor surface is covered with snow, ice, dirt, water or seal, or equipped with other parts, remove them. If the cancel code persists, replace the sonar sensor.
|
| 0X0D | RR Sonar Dirty HALT II | Substance adhered to the sonar sensor (right corner).
NOTE:
If the sensor surface is covered with snow, ice, dirt, water or seal, or equipped with other parts, remove them. If the cancel code persists, replace the sonar sensor.
|
| 0X0E | RL Sonar Dirty HALT II | Substance adhered to the sonar sensor (left corner).
NOTE:
If the sensor surface is covered with snow, ice, dirt, water or seal, or equipped with other parts, remove them. If the cancel code persists, replace the sonar sensor.
|
| 0X12 | ASIC overvoltage, overheat | Temperature of RAB Control Module extremely increased.
NOTE:
If the cancel code persists even if the temperature inside the vehicle is normal, replace RAB Control Module.
|
| 0X13 | Rear sensor high temperature | Temperature of the sonar sensor extremely increased.
NOTE:
This may temporarily occur when the ambient temperature is extremely high or after driving with the engine highly loaded. If the cancel code persists, replace the sonar sensor.
|
| 0X17 | Trailer towing | The sonar sensor detected the trailer or towing parts connected to the rear side of the vehicle.
NOTE:
If the cancel code persists even if the trailer or towing parts are not connected, replace the sonar sensor.
|
| 0X18 | RAB forced OFF instruction from EyeSight | RAB Control Module received an OFF instruction sent from EyeSight due to EyeSight malfunction.
NOTE:
If the cancel code persists, perform the diagnosis of EyeSight.
|