DTC P0103: Mass Or Volume Air Flow Sensor "A" Circuit High: Notes

1. -

DTC detecting condition:

Immediately at fault recognition

Trouble symptom:

Improper idling
Engine stall
Poor driving performance

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Refer to ENGINE (Diagnostics) (H4DO)>Basic Diagnostic Procedure>PROCEDURE .

CHECK DATA MONITOR .
1. Start the engine.
2. Using the Subaru Select Monitor, read the value in [Air Flow Rate from Mass Air Flow Sensor].
  NOTE: For detailed operation procedures. Refer to "Common (Diagnostics)". Refer to COMMON (DIAG)>DATA MONITOR .
Is the value of [Mass Air Flow] 232.32 [g/s] (30.74 lb/min) or more?

Yes : Go to 2.

No : Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
CHECK FOR POOR CONTACT .
Check for poor contact of mass air flow and intake air temperature sensor connector.

Is there poor contact of mass air flow and intake air temperature sensor connector?

Yes : Repair the poor contact of mass air flow and intake air temperature sensor connector.

No : Replace the mass air flow and intake air temperature sensor. Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>Mass Air Flow and Intake Air Temperature Sensor .