LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Anti-Theft System - Security And Locks (Service Information) >> Security System >> Inspection >> Check Ignition Switch Circuit

Check Ignition Switch Circuit

  1. CHECK DATA MONITOR  .

    Display the data of [BATT voltage (control)] and [Power Supply Voltage] using Subaru Select Monitor. Refer to BODY CONTROL (DIAGNOSTICS)>DATA MONITOR .

    Does the [Power Supply Voltage] indicate 0 V when the ignition switch is OFF, and fall within a range of ±1 V from the [BATT voltage (control)] when the ignition switch is ON?

    Yes  : The ignition switch input circuit is OK.

    No  : Go to  2.

  2. CHECK IGNITION SWITCH CIRCUIT  .
    1. Turn the ignition switch to OFF.
    2. Disconnect the connector of body integrated unit.
    3. Turn the ignition switch to ON.
    4. Measure the voltage between the body integrated unit connector and chassis ground.

      Connector & terminal 

      (i6) No. 12 (+) - Chassis ground (-):

    Is the voltage 10 V or more?

    Yes  : Check body integrated unit. Refer to BODY CONTROL (DIAGNOSTICS)>Basic Diagnostic Procedure .

    No  : Check the harness for open or short circuit between body integrated unit and fuse.

scientia non olet · About LEMON Manuals