DTC P1C00: Battery Monitor Module "A" Performance: Notes
- -
DTC detecting condition:
Immediately at fault recognition
NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Refer to ENGINE (DIAGNOSTICS) (H4DO)>Basic Diagnostic Procedure>PROCEDURE .
- CHECK DTC
.
- Turn the ignition switch to ON.
- Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Refer to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC P1C00 displayed? (Current malfunction)
Yes : Replace the battery sensor. Refer to STARTING/CHARGING SYSTEMS) (H4DO)>BATTERY SENSOR .
No : Even if DTC is detected, it has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.