DTC P0420: Catalyst System Efficiency Below Threshold Bank 1: Notes

1. - 

DTC detecting condition: 

Detected when two consecutive driving cycles with fault occur.

Trouble symptom: 

• Engine stall
• Idle mixture is out of specifications

1. CHECK DTC AND FREEZE FRAME DATA  .
   1. Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Refer to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
   2. Read the freeze frame data. Refer to ENGINE (DIAGNOSTICS) (H4DO)>Freeze Frame Data . Refer to ENGINE (DIAGNOSTICS) (H4DO)>General Scan Tool .
   3. Save the displayed DTC and freeze frame data.

   Is DTC other than P0420 displayed? (Current malfunction)

   Yes  : Check the appropriate DTC using the "Diagnostic Trouble Code (DTC)". Refer to ENGINE (DIAGNOSTICS) (H4DO)>DIAGNOSTIC TROUBLE CODE (DTC) .

   No  : Go to  2.

2. CHECK ENGINE OIL CONSUMPTION  .

   Check the engine oil amount. Refer to LUBRICATION (H4DO)>Engine Oil .

   Is white smoke emitted from the muffler?

   Yes  : Check the engine, and repair the defective part. Refer to MECHANICAL (H4DO)>Symptoms and causes .

   After repairing the engine, replace all the catalytic converters. Refer to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO)>Front Catalytic Converter . Refer to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO)>Rear Catalytic Converter .

   No  : Go to  3.

3. CHECK EXHAUST SYSTEM  .

   Check the following items regarding exhaust system.

   • Loose or detached nut and bolt
   • Exhaust gas leakage
   • Air suction
   • Hole on exhaust pipe

   Is there any trouble?

   Yes  : Repair or replace the exhaust system. Refer to EXHAUST (H4DO)>General Description .

   No  : Go to  4.

4. CHECK CATALYTIC CONVERTER  .
   1. Start the engine and warm up completely.
   2. Read the waveform data of rear oxygen sensor during idling using Subaru Select Monitor.
   3. Check the waveform by waggling the connector between ECM and rear oxygen sensor.
      • At normal condition

        Courtesy of SUBARU OF AMERICA, INC.

      • At abnormal condition (noise input)

        Courtesy of SUBARU OF AMERICA, INC.

   Is an abnormal waveform displayed?

   Yes  : Connect the connector after checking the following items, and check the waveform again while waggling.

   • Check the contact point of the connector that caused disturbed waveform. If faulty, repair or replace it.
   • If any problem is not found, It is possible that a temporary poor contact occurs in the connector.

   No  : Replace all the catalytic converters. Refer to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO)>Front Catalytic Converter . Refer to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO)>Rear Catalytic Converter .