Belt Assembly Front Inner

CAUTION:

Before installation, make sure that the correct part is used.
During installation, make sure that the seat belts are not twisted.
Check that there is no pinching of the seat belt harness. Wrong harness rooting may cause the harness short from pinch.
Do not forget the spring wave washer, when installing the belt assembly front INN.
If the passenger's seat is removed, be sure to perform [Rezeroing] for the occupant detection system after installing the seat to the vehicle. Refer to OCCUPANT DETECTION (DIAGNOSTICS)>REZERO .
For model with door mirror interlocked seat position memory, initialize the power seat & remote control module after installing the driver's seat in the vehicle if the seat has been removed. Refer to SEATS>POWER SEAT SYSTEM>ADJUSTMENT .

Install the belt assembly front INN.

Install the wave washer, belt assembly front INN and nut in order and then tighten the nut.
Tightening torque:

38 N.m (3.9 kgf-m, 28.0 ft-lb)

Locate the seat belt harness and retain it with a harness clip.

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

NOTE: For details about harness routing behind the seat, refer to SEATS>FRONT SEAT>ASSEMBLY>CONNECTOR & HARNESS .

Install the seat assembly to the body. Refer to SEATS>FRONT SEAT>INSTALLATION .
Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .