Rear Seat Reclining System: Installation

Use the following procedures to install the stay rear floor and spring BRKT.

Courtesy of SUBARU OF AMERICA, INC.
1. Temporarily tighten the bolt (a).
2. Tighten the bolts (b) and (c) to the specified torque.
3. Tighten the bolts (a) and (d) and the nut (e) to the specified torque.
Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)
Install the striker backrest rear.
Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)
Install the trim panel assembly apron.
Install the rear seat. Refer to SEATS>REAR SEAT>INSTALLATION .
Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .