Vehicle Dynamics Control (VDC) System: General Description: Caution

When performing service operation, refer to REPAIR CONTENTS>REPAIR CONTENTS .
When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.
Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.
Keep the disassembled parts in order and protect them from dust and dirt.
When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.
Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
Be sure to tighten fasteners including bolts and nuts to the specified torque.
Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.
If the hydraulic unit assembly VDC, bracket COMPL hydraulic unit VDC, steering wheel and the sensor assembly VDC steering (steering roll connector) are removed, installed or replaced, perform "VSC (VDC) Centering Mode" of the VDC. Refer to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .