LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Forester Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle System (Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0965: Pressure Control Solenoid "B" Control Circuit Range/Performance >> Notes

DTC P0965: Pressure Control Solenoid "B" Control Circuit Range/Performance: Notes

  1. DTC detecting condition: 

    Immediately at fault recognition

    Trouble symptom: 

    • Engine speed increases abruptly, and cannot accelerate.
    • Excessive slippage is felt.

    Wiring diagram: 

    CVT control system Ref. to WIRING SYSTEM>CVT CONTROL SYSTEM .

G13228337Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
  1. CHECK DTC. 

    Read the DTC using Subaru Select Monitor. Ref. to TRANSMISSION (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Besides DTC P0965, is any of the DTC P0717, P0966, P0967 or P2747 displayed?

    Yes:  Perform the diagnosis according to DTCs other than P0965. Ref. to TRANSMISSION (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

    No:  Go to  2.

  2. CHECK F & R SOLENOID (ACTIVE TEST). 
    1. Turn the ignition switch to ON.
    2. Using the Subaru Select Monitor, perform the active test for F & R solenoid. Ref. to TRANSMISSION (DIAGNOSTICS)>ACTIVE TEST .

      Is 300 → 500 → 700 mA indicated at the active test, and does [Actual Forward & Reverse Linear Solenoid Current] follow [Commanded Forward & Reverse Linear Solenoid Current]?

      Yes:  Go to  3.

      No:  Go to  4.

  3. CHECK FOR POOR CONTACT. 

    Check for poor contact of harness and connector between TCM and F & R solenoid.

    Is there poor contact?

    Yes:  Repair the poor contact of harness and connector.

    No:  Recheck the poor contact of harness and connector. Replace the TCM if no fault is found. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>TRANSMISSION CONTROL MODULE (TCM) .

  4. CHECK F & R SOLENOID. 
    1. Turn the ignition switch to OFF.
    2. Disconnect the TCM connector.
    3. Measure the resistance between TCM connector and transmission body.

      Connector & terminal 

      (T10) No. 16 - Transmission body:

      Is the resistance approximately 3.5 - 7.1 Ω? (When cold)

      Yes:  Replace the control valve body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>CONTROL VALVE BODY .

      No:  Repair or replace the harness.