LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Forester Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle System (Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0961: Pressure Control Solenoid "A" Control Circuit Range/Performance >> Notes

DTC P0961: Pressure Control Solenoid "A" Control Circuit Range/Performance: Notes

  1. DTC detecting condition: 

    Immediately at fault recognition

    Trouble symptom: 

    • Acceleration is poor during standing start.
    • Shift control malfunction
    • Engine speed increases abruptly.

    Wiring diagram: 

    CVT control system Ref. to WIRING SYSTEM>CVT CONTROL SYSTEM .

G13228323Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
  1. CHECK DTC. 

    Read the DTC using Subaru Select Monitor. Ref. to TRANSMISSION (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Besides DTC P0961, is DTC P0962 or P0963 displayed?

    Yes:  Perform the diagnosis according to DTCs other than P0961. Ref. to TRANSMISSION (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

    No:  Go to  2.

  2. CHECK SECONDARY SOLENOID (ACTIVE TEST). 
    1. Turn the ignition switch to ON.
    2. Using the Subaru Select Monitor, perform the active test for secondary solenoid. Ref. to TRANSMISSION (DIAGNOSTICS)>ACTIVE TEST .

      Is 300 → 500 → 700 mA indicated at the active test, and does [Secondary Actual Current] follow [Secondary Set Current]?

      Yes:  Go to  3.

      No:  Go to  4.

  3. CHECK FOR POOR CONTACT. 

    Check for poor contact of harness and connector between TCM and secondary solenoid.

    Is there poor contact?

    Yes:  Repair the poor contact of harness and connector.

    No:  Recheck the poor contact of harness and connector. Replace the TCM if no fault is found. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>TRANSMISSION CONTROL MODULE (TCM) .

  4. CHECK SECONDARY SOLENOID. 
    1. Turn the ignition switch to OFF.
    2. Disconnect the TCM connector.
    3. Measure the resistance between TCM connector and transmission body.

    Connector & terminal 

    (T10) No. 32 - Transmission body:

    Is the resistance approximately 4.8 - 8.4 Ω? (When cold)

    Yes:  Replace the control valve body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>CONTROL VALVE BODY .

    No:  Repair or replace the harness.