Check Memory Height Switch Input Circuit
Wiring diagram:
Power rear gate system Ref. to WIRING SYSTEM>POWER REAR GATE SYSTEM>WIRING DIAGRAM .
- CHECK DATA MONITOR.
Using the Subaru Select Monitor, check the following items in the [Data Monitor] of [Power Rear Gate]. Ref. to POWER REAR GATE (DIAGNOSTICS)>DATA MONITOR .
- Memory stop SW
Does the display switch between OFF ←→ ON according to memory height SW operation?
Yes: Input circuit is normal.
No: Go to 2.
- CHECK HARNESS (OPEN CIRCUIT).
- Disconnect the Power rear gate Control Module connector in the order of (R423) → (R422).
- Disconnect the memory height SW connector.
- Measure the resistance between Power rear gate Control Module connector and memory height SW connector.
Connector & terminal
(R422) No. 8 - (i257) No. 1:
Is the resistance less than 10 Ω?
Yes: Go to 3.
No: Repair or replace the open circuit of harness.
- CHECK HARNESS (GROUND SHORT CIRCUIT).
Measure the resistance between Power rear gate Control Module connector and chassis ground.
Connector & terminal
(R422) No. 8 - Chassis ground:
Is the resistance 1 MΩ or more?
Yes: Go to 4.
No: Repair or replace the short circuit of the harness.
- CHECK HARNESS (OPEN CIRCUIT).
Measure the resistance between memory height SW connector and chassis ground.
Connector & terminal
(i257) No. 4 - Chassis ground:
Is the resistance less than 10 Ω?
Yes: Go to 5.
No: Repair or replace the open circuit of harness.
- CHECK MEMORY HEIGHT SW.
Measure the resistance between switch terminals.
Terminals
No. 1 - No. 4:
Is the resistance 1 MΩ or more at OFF, and less than 1 Ω at ON?
Yes: Go to 6.
No: Replace the memory height SW. Ref. to POWER REAR GATE SYSTEM>MEMORY HEIGHT SWITCH .
- CHECK CONNECTOR.
Is there poor contact of connector?
Yes: Repair or replace the poor contact of connector.
No: Replace Power rear gate Control Module. Ref. to POWER REAR GATE SYSTEM>POWER REAR GATE CONTROL MODULE .