M/T Clutch System: Flywheel: Installation

Press-in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.
CAUTION: Do not press the bearing inner ring.

Courtesy of SUBARU OF AMERICA, INC.
Temporarily install the crankshaft position sensor plate and flywheel.
NOTE: Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.
Attach the ST.
Preparation tool:

ST: CRANKSHAFT STOPPER (498497100)

Courtesy of SUBARU OF AMERICA, INC.

Tighten the flywheel mounting bolts in two stages.

Tighten the flywheel attachment bolts.

Tightening torque:

30 N.m (3.1 kgf-m, 22.1 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

While checking the tightening angle with the angle gauge, further tighten the flywheel mounting bolts.
Tightening angle:

30° - 35°

Install the clutch disc and clutch cover. Ref. to CLUTCH SYSTEM>CLUTCH DISC AND COVER>INSTALLATION .
Install the manual transmission assembly.
- 5MT model: Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (5MT)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
- 6MT model: Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .