LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Power Steering System (Service Information) >> Steering Wheel >> Disassembly

Steering Wheel: Disassembly

  1. Remove the screws on the back of the steering wheel.
    • Model without paddle shift: upper side two locations
    • Model with paddle shift: four locations
    G11245573Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the connector and remove the paddle shift switch. (Model with paddle shift)
  3. Remove the cover - steering wheel LWR.
    CAUTION: Carefully remove the cover - steering wheel LWR and the steering wheel. Do not pull with excessive force. Otherwise, heat wire between cover - steering wheel LWR and steering wheel may be damaged. (Model with steering heater)
    1. Remove the connectors and screws. (Model with MID switch and model with steering heater switch)
    2. Release the claws and harness clips, and detach the cover - steering wheel LWR.
      G11245575Courtesy of SUBARU OF AMERICA, INC.
      NOTE: For model with steering heater, disconnect the connector with the cover - steering wheel LWR removed from steering wheel, and remove the steering heater unit. Also, remove the heater elements RH and LH secured with double-sided tape from the cover - steering wheel LWR.
  4. Release the claws and remove the screws, then detach the satellite switch.
    G13226059Courtesy of SUBARU OF AMERICA, INC.
  5. Release the claws, and then remove the switch assembly - steering (MID). (Model with MID switch)
    G13226060Courtesy of SUBARU OF AMERICA, INC.
  6. Release the connector, screws and claws, and remove the steering heater switch and steering heater unit. (Model with steering heater)
    G13200394Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals