LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Keyless Access Control Module >> Removal

Keyless Access Control Module: Removal

  1. Disconnect the ground terminal from 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: For the hybrid model, disconnect the battery negative terminal.
  2. Remove the pocket assembly and the back panel - pocket. Refer to EXTERIOR/INTERIOR TRIM>GLOVE BOX>REMOVAL .
  3. Remove the keyless access Control Module.
    CAUTION: Be careful to keep water and other foreign materials away from the keyless access Control Module terminals.
    1. Disconnect the connector.
    2. Release the claws using a flat tip screwdriver or similar tool wrapped with protection tape.
    3. Release the guides and pull out the keyless access Control Module.
      G11246396Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals