LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> BRZ tS >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Anti-Theft System (Service Information)) >> Auto Alarm System >> Data monitor/active test

Data monitor/active test

WARNING: This page is about a different car, the 2019 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Data monitor
    NOTE: By using the SSM4 and reading [Data monitor], you can read the statuses and values for switches, sensors, actuators, and other items without removing parts. Because the non-intrusive inspection allows you to read the intermittent statuses or signals without interfering with parts or lines, it is very convenient. Diagnostic time can be saved by reading the [Data monitor] information at the initial stage of the troubleshooting.
    1. Connect the SSM4 to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn on the SSM4.
    4. Enter the following menus: [Body Control] →[Data monitor]
    RANGE DESCRIPTION - MAIN BODY

    Item name Description/display range Normal value Remarks
    [Security System] Anti-theft system/OFF or ON Customization status is displayed. -
    [D Door Courtesy] Front RH door courtesy light switch signal/OFF or ON OFF: Driver's door is closed ON: Driver's door is open. -
    [D Door Lock Pos] Front RH door lock position switch signal/OFF or ON OFF: The driver's door is locked. ON: Driver's door is locked. -
    [P Door Courtesy] Front LH door courtesy light switch signal/OFF or ON OFF: The passenger's door is closed. ON: The passenger's door is open. -
    [P Door Lock Pos] Front LH door lock position switch signal/OFF or ON OFF: Passenger's door is locked ON: Passenger's door is unlocked -
    [Luggage Courtesy SW] Trunk courtesy switch/OFF or ON OFF: The trunk is closed. ON: The trunk is open. -
    [Ignition] Engine switch condition/OFF or ON OFF: IG OFF ON: IG ON -
    [ACC SW] Engine switch condition/OFF or ON OFF: IG OFF ON: ACC ON -
  2. Active test
    NOTE: By performing an [Active Test] with SSM4, you can operate relays, VSV, actuators and other devices without removing any parts. This non-intrusive inspection is very useful because intermittent operation is possible without disturbing any parts or wiring. By performing an [Active Test] at an initial phase of troubleshooting, you can save time for diagnosis. [Data monitor] can be displayed during [Active Test].
    1. Connect the SSM4 to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn on the SSM4.
    4. Enter the following menus: [Body Control] →[Active Test]
    5. Based on the SSM4 display contents, perform an [Active Test].
    RANGE DESCRIPTION - MAIN BODY

    Item name Description/display range Normal value Remarks
    [Security Indicator] Security indicator light ON/OFF -
    [Horn Output] Vehicle horn ON/OFF -
scientia non olet · About LEMON Manuals