Exhaust Side

RH SIDE.
1. Install the backup ring to the oil control solenoid.
2. Using a new O-ring, install the oil control solenoid.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
3. Connect the connector.
4. Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DOTC)>AIR INTAKE DUCT>INSTALLATION .
5. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
LH SIDE.
1. Install the backup ring to the oil control solenoid.
2. Using a new O-ring, install the oil control solenoid.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
3. Connect the connector.
4. Install the reservoir tank. Ref. to COOLING (H4DOTC)>RESERVOIR TANK>INSTALLATION .
5. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .