LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Ascent Base >> Repair and Diagnosis >> Steering >> Steering Control Systems >> Power Steering System (Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC C2551: Power Supply Relay

DTC C2551: Power Supply Relay

DTC detecting condition: 

Trouble symptom: 

Wiring diagram: 

Electric power steering system Ref. to WIRING SYSTEM>ELECTRIC POWER STEERING SYSTEM .

G13202799Courtesy of SUBARU OF AMERICA, INC.
NOTE: If power supply voltage failure exists at the vehicle side, the warning light goes off if the normal voltage returns.
  1. CHECK BATTERY. 

    Check the battery. Ref. to STARTING/CHARGING SYSTEMS (H4DOTC)>BATTERY>INSPECTION .

    Is the check result OK?

    Yes  : Go to  2.

    No  : Charge or replace the battery.

  2. CHECK BATTERY TERMINAL AND FUSE. 

    Check the battery terminals and the fuse.

    Is the check result OK?

    Yes  : Go to  3.

    No  : Repair or replace faulty parts.

  3. CHECK WIRING HARNESS. 
    1. Disconnect the connector. (B205, B206)
    2. Turn the ignition switch to ON.
    3. Using a tester and special tool harness, check the voltage between terminals.

      Connector and terminal 

      (B205) No. 2 (+) - Chassis ground (-):

    Is the voltage 12 V or more?

    Yes  : Go to  4.

    No  : Repair the open circuit of harness or the poor contact of connector between the power steering control module and the battery.

  4. CHECK GROUND CIRCUIT. 
    1. Turn the ignition switch to OFF.
    2. Using a tester and special tool harness, check the resistance between terminals.

      Connector and terminal 

      (B205) No. 1 - Chassis ground:

    Is the resistance less than 1 Ω?

    Yes  : Go to  5.

    No  : Repair the open circuit or poor contact of the harness between the power steering control module and chassis ground.

  5. CHECK HARNESS. 
    1. Turn the ignition switch to OFF.
    2. Disconnect the power steering control module connector (B452).
    3. Using a tester and special tool harness, check the resistance between harness terminals.

      Connector and terminal 

      (B206) No. 1 - (B452) No. 1:

      (B206) No. 2 - (B452) No. 2:

    Is the resistance less than 1 Ω?

    Yes  : Replace the steering gearbox. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>ELECTRIC POWER STEERING GEARBOX .

    No  : Repair or replace the harness.