LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Ascent Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical System >> V-belt >> Installation >> V-Belt >> Notes

Engine Mechanical System: V-belt: Installation: V-Belt: Notes

  1. Attach the tool to the V-belt tensioner assembly, and rotate the tool clockwise to remove the V-belt as shown in the figure.
    CAUTION:
    • When reusing the V-belt, wipe off dust and water with cloth.
    • Do not use the V-belt if there is any oil, grease or coolant on the belt.
    • Be careful not to rub the V-belt end surface with bare hands; exposed core may cause injury.
    • Wipe off any dust, oil and water on the groove of each pulley with cloth.
    Fig 1: Engine Drive Belt Routing Diagram
    G13198729Courtesy of SUBARU OF AMERICA, INC.
  2. When working on the vehicle
    NOTE: When working on the vehicle, perform the following steps also.
    1. Install the V-belt cover.

      Tightening torque: 

      7 N.m (0.7 kgf.m, 5.2 ft-lb)

scientia non olet · About LEMON Manuals