DTC P003A: Turbocharger/Supercharger Boost Control "A" Position Exceeded Learning Limit: Notes
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
Trouble symptom:
- Poor driving performance
- Poor acceleration
- CHECK DTC.
- Turn the ignition switch to ON.
- Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC P003A displayed? (Current malfunction)
Yes : Go to 2.
No : Check the appropriate DTC using the "Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .
- CHECK DATA MONITOR.
Using the Subaru Select Monitor, read the value in [Electric Waste Gate Valve Position Sensor Learning Value at the Full-closed Position].
NOTE: For detailed operation procedures, refer to "Common (Diagnostics)". Ref. to COMMON (DIAG)>DATA MONITOR .Is the value in [Electric Waste Gate Valve Position Sensor Learning Value at the Full-closed Position] less than -3 mm (-0.12 in) or more than 4.3 mm (0.17in)?
Yes : Go to 3.
No : Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness or temporary contamination and clogging at the valve port may be the cause. - CHECK APPEARANCE OF TURBOCHARGER (ELECTRONIC WASTEGATE VALVE).
- Turn the ignition switch to OFF.
- Remove the turbocharger. Ref. to INTAKE (INDUCTION) (H4DOTC)>TURBOCHARGER>REMOVAL .
- Check the appearance of turbocharger to make sure that there is no foreign matter pinched in the electronic wastegate valve.CAUTION: Do not remove the electronic air by-pass valve and electronic wastegate valve since they are non-disassembled parts.
Is the check result OK?
Yes : Replace the turbocharger. Ref. to INTAKE (INDUCTION) (H4DOTC)>TURBOCHARGER>REMOVAL .
No : Remove the foreign matters from the turbocharger.