LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Curtain Airbag Module >> Installation

Curtain Airbag Module: Installation

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  • When installing the curtain airbag module, install a specified part at specified place.
  • Be careful not to damage the curtain airbag module during installation.
  • Never open the curtain airbag module before activation. Never reuse the deployed curtain airbag module.
  • Make sure that there are no foreign matter on airbag module.
  • When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off.
  • Do not reuse the upper clips of the trim panel - center pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.
  • For installation of the stereo camera cover assembly, refer to "INSTALLATION", "Stereo Camera" in the "EyeSight" service information and observe the precautions for installation. Refer to EYESIGHT>STEREO CAMERA>INSTALLATION .
  1. Before installation, inspect the following items and replace any faulty part with a new one.
    • Airbag cover is scratched or torn.
    • Harness and/or connector is cracked, deformed or open.
    • Harness wire is exposed.
    • Mounting bracket and securing clip are cracked or deformed.
  2. Install the curtain airbag module.
    CAUTION:
    • Be sure to insert the connector in completely until it is locked.
    • Press in the push lock of the direct type connector securely. Then pull it gently to make sure that it is locked.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  3. Install the trim panel - roof assembly. Refer to EXTERIOR/INTERIOR TRIM>ROOF TRIM>INSTALLATION .
  4. Connect the battery ground terminal. Refer to NOTE>NOTE>BATTERY .
    NOTE: After connecting the battery sensor terminal, place the select lever in the "P" position.
scientia non olet · About LEMON Manuals