"S#", "I" Or "S" Blinks On SI-Drive Mode Display In The Combination Meter After Switching SI-Drive Modes
WARNING: This page is about a different variant/trim than selected.
NOTE:
In this case, there is a fault other than in SI-DRIVE system.
- CHECK MALFUNCTION INDICATOR LIGHT.
- Start the engine.
- Check if malfunction indicator light illuminates.
Does the malfunction indicator light illuminate?
Yes: Read the DTC using Subaru Select Monitor and check the indicated DTC. Refer to ENGINE (DIAGNOSTICS) (STI)>LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
No: Go to 2.
- CHECK ENGINE COOLANT TEMPERATURE GAUGE.
- Turn the ignition switch to ON.
- Check the engine coolant temperature gauge.
Does it indicate overheating?
Yes: Inspect for the cause of overheating and repair.
No: Go to 3.
- CHECK COMBINATION METER INDICATION.
- Turn the ignition switch to ON.
- Switch SI-DRIVE modes.
- Check the SI-DRIVE mode display in the combination meter.
Does "S#", "I" or "S" of the SI-DRIVE mode blink in combination meter?
Replace the combination meter. Refer to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .
No: Perform test driving to check the malfunction indicator light and engine coolant temperature gauge. Complete the diagnosis if they are normal.