Section 16 (Starting System & Charging System (STI)): General Description: Specification
WARNING: This page is about a different variant/trim than selected.
| Item | Specifications | ||||
|---|---|---|---|---|---|
| Starter | Type | Reduction type | |||
| Model | 428000-5760 | ||||
| Manufacturer | DENSO | ||||
| Voltage and output | 12 V - 1.0 kW | ||||
| Direction of rotation | Counterclockwise (when observed from pinion) | ||||
| Number of pinion teeth | 9 | ||||
| Armature commutator runout | Standard | 0.05 mm (0.0020 in) | |||
| Limit | 0.10 mm (0.0039 in) | ||||
| Armature depth of segment mold | Standard | 0.5 mm (0.020 in) | |||
| Brush length | Standard | 12.3 mm (0.484 in) | |||
| Limit | 7.0 mm (0.276 in) | ||||
| Brush spring force | Standard | 15.9 - 19.5 N (1.62 - 1.99 kgf, 3.57 - 4.38 lbf) | |||
| Limit | 2.5 N (0.25 kgf, 0.56 lbf) | ||||
| No-load characteristic cs | Voltage | 11 V | |||
| Current | 90 A or less | ||||
| Generator | Type | Rotating-field three-phase type, voltage regulator built-in type, each with load response control system | |||
| Model | A3TG6591 | ||||
| Manufacturer | Mitsubishi Electric | ||||
| Voltage and output | 12 V - 110 A | ||||
| Polarity on ground side | Negative | ||||
| Direction of rotation | Clockwise (when observed from pulley side) | ||||
| Stator connection | 3-phase Y-type | ||||
| Output current | 1, 500 r/min - 50 A or more 2, 500 r/min - 91 A or more 5, 000 r/min - 105 A or more |
||||
| Regulated voltage | 14.1 - 14.8 V [20°C (68°F)] | ||||
| Rotor slip ring outer diameter | Standard | 22.7 mm (0.894 in) | |||
| Limit | 22.1 mm (0.870 in) | ||||
| Brush length | Standard | 18.5 mm (0.728 in) | |||
| Limit | 5.0 mm (0.197 in) | ||||
| Battery | Type | 75D23L | |||
| Nominal capacity | 5 HR: 53 Ah [25°C (77°F)] | ||||
| Nominal voltage | 12 V | ||||
| CCA | 470 A | ||||
| BCI group number(1) | 35 | ||||
|
|||||