Sunroof Switch: Inspection
- Disconnect the harness connector of sunroof switch.
- Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. Inspection conditions Standard Connector 1 - 3 Open Less than 1 Ω (b): Slide switch 4 - 3 Close Less than 1 Ω 1 - 3 Tilt up Less than 1 Ω (a): Tilt switch 4 - 3 Tilt down Less than 1 Ω - Replace the sunroof switch if the inspection result is not within the standard value.