Sunroof Assembly: Installation
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM".
Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
- For installation of the stereo camera cover assembly, refer to "INSTALLATION", "Stereo Camera" in the "EyeSight" instructions and observe the precautions for installation.
Refer to EYESIGHT>STEREO CAMERA>INSTALLATION .
- Be careful not to snag the harness.
- Install each connector and the drain tube - sunroof.
Tightening torque:
Connector holder: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Ground bolt: 13 N.m (1.3 kgf-m, 9.6 ft-lb)
- Install the cover side sill - front.
- Install the sunroof bracket and the rail assembly - sunroof.
Tightening torque:
6 N.m (0.6 kgf-m, 4.4 ft-lb)
- Connect the harness connector of the drain tube - sunroof and the motor assembly.CAUTION: Insert the four drain tubes 15 mm (0.59 in) or more into the drain pipes (A).
- Install the bracket - assist rail.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the trim panel - roof assembly.
- Using a new TORX®
bolt, install the lid assembly - sunroof.
Tightening torque:
4.5 N.m (0.5 kgf-m, 3.3 ft-lb)