Rear Outer Handle: Installation

Before installation, check the following items.
- Lever is free from deformation.
- Grease is applied sufficiently to lever joints.
  If grease is insufficient, add it as necessary before assembling.
- If the lever is faulty, replace the frame assembly - rear door outer.
Install the frame assembly - rear door outer.
Preparation tool:

TORX^® T30

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the spacer - door handle outer.
Install the handle - door outer.
1. Insert the end of the handle - door outer to the frame assembly - rear door outer.
2. Push forward while inserting the rear end of the handle - door outer to the frame assembly - rear door outer.
3. Lock the holder of the frame assembly - rear door outer.
Install the cover - handle rear outer.
Preparation tool:

TORX^® T30

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the latch and actuator assembly - rear.
CAUTION:
- Do not reuse the TORX^® bolt. Always replace with a new part.
- Hook the lever to the latch shaft.
Preparation tool:

TORX^® T30

Tightening torque:

6.5 N.m (0.7 kgf-m, 5.2 ft-lb)
Install the sealing cover - rear door.
Install the trim panel - rear door.
Connect the battery ground terminal.
Refer to NOTE>NOTE>BATTERY .