Check Hazard Light Operation

CHECK HAZARD LIGHT OPERATION.
Make sure the hazard light blinks when hazard switch is turned to ON.

Does the hazard light blink?

Yes: Go to 2.

No: Check the hazard light circuit.
CHECK BODY INTEGRATED UNIT SETTING.
Display the data of «Abnormal warning lamp flashing setting» using Subaru Select Monitor.

NOTE: For detailed operation procedures, refer to "Application help".

Is the setting ON?

Yes: Go to 3.

No: Turn the setting to ON.
CHECK DATA MONITOR.
Display the data of «Hazard Output» using Subaru Select Monitor.

Is output signal present when operating the transmitter LOCK/UNLOCK button?

Yes: Go to 4.

No: Go to 5.
CHECK KEYLESS ENTRY OPERATION.
Press the LOCK/UNLOCK button of the keyless transmitter.

Does it operate properly?

Yes: Replace the body integrated unit. Refer to SECURITY AND LOCKS>BODY INTEGRATED UNIT .

No: Check keyless entry system. Refer to SECURITY AND LOCKS>KEYLESS ENTRY SYSTEM>INSPECTION>SYMPTOM CHART .
CHECK HAZARD LIGHT CIRCUIT.
1. Disconnect the connectors of the body integrated unit and turn signal & hazard unit.
2. Check the harness between body integrated unit and turn signal & hazard unit.
  Connector & terminal
  
  (il71) No. 18 - (B32) No. 8:
Is harness normal?

Yes: Check body integrated unit. Refer to BODY CONTROL SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .

No: Repair or replace the harness.