DTC P0123: Throttle/Pedal Position Sensor/Switch "A" Circuit High: Notes

DTC detecting condition:

Immediately at fault recognition

Trouble symptom:

Improper idling
Engine stalls.
Poor driving performance

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Mode Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>CLEAR MEMORY MODE>OPERATION , and inspection mode Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>INSPECTION MODE>PROCEDURE ..
Use the check board when measuring the ECM terminal voltage and resistance.

Wiring diagram:

Engine Electrical System Refer to WIRING SYSTEM>ENGINE ELECTRICAL SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR.
1. Turn the ignition switch to OFF.
2. Disconnect the connector from ECM.
3. Disconnect the connectors from electronic throttle control.
4. Measure the resistance of harness between ECM connector and electronic throttle control connector.
  Connector & terminal
  
  (E158) No. 17 - (E57) No. 1:
  
  (E158) No. 30 - (E57) No. 3:
Is the resistance less than 1 Ω?

Yes: Go to 2.

No: Repair the open circuit of harness between ECM connector and electronic throttle control connector.
CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR.
1. Connect the connector to ECM.
2. Measure the resistance between electronic throttle control connector and engine ground.
  Connector & terminal
  
  (E57) No. 3 - Engine ground:
Is the resistance less than 5 Ω?

Yes: Go to 3.

No: Repair the harness and connector.
NOTE:
In this case, repair the following item:
- Open circuit of harness between ECM connector and engine ground
- Poor contact of ECM connector
- Poor contact of coupling connector
CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR.
1. Turn the ignition switch to ON.
2. Measure the voltage between electronic throttle control connector and engine ground.
  Connector & terminal
  
  (E57) No. 1 (+) - Engine ground (-):
Is the voltage 5 V or more?

Yes: Repair the short circuit to power in the harness between ECM connector and electronic throttle control connector.

No: Go to 4.
CHECK HARNESS BETWEEN ECM AND ELECTRONIC THROTTLE CONTROL CONNECTOR.
1. Turn the ignition switch to OFF.
2. Disconnect the connector from ECM.
3. Measure the resistance between ECM connectors.
  Connector & terminal
  
  (E158) No. 17 - (E158) No. 18:
Is the resistance 1 MΩ or more?

Yes: Repair the poor contact of electronic throttle control connector. Replace the electronic throttle control if defective. Refer to FUEL INJECTION (FUEL SYSTEMS) (EXCEPT FOR STI)>THROTTLE BODY .

No: Repair the short circuit to power in the harness between ECM connector and electronic throttle control connector.