LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> Outback 2.5i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Cooling System (3.6L)) >> Radiator >> Removal

Section 2 (Engine Cooling System (3.6L)): Radiator: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: The radiator is pressurized when the engine and radiator are hot. Wait until engine and radiator cool down before working on the radiator.
  1. Remove the collector cover.
    1. Carefully pull up the rear of collector cover at two positions (A).
    2. Carefully pull up the front of collector cover at two positions (B) while moving it forward.
      G11585612Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  3. Remove the air intake duct. Ref. to INTAKE (INDUCTION) (H6DO)>AIR INTAKE DUCT>REMOVAL .
  4. Remove the front bumper. Ref. to EXTERIOR/INTERIOR TRIM>FRONT BUMPER>REMOVAL .
  5. Remove the grille bracket.
    NOTE: Remove six clips when removing the grille bracket.
    G10264169Courtesy of SUBARU OF AMERICA, INC.
  6. Drain engine coolant. Ref. to COOLING (H6DO)Engine Coolant>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  7. Disconnect the radiator outlet hose from thermostat cover.
    G10264165Courtesy of SUBARU OF AMERICA, INC.
  8. Disconnect the CVTF radiator inlet hose and CVTF radiator outlet hose from the CVTF cooler pipe assembly.
    NOTE: Plug the CVTF cooler pipe assembly to prevent CVTF from leaking.
    G10264171Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the CVTF radiator inlet hose and CVTF radiator outlet hose from the clips of the radiator fan shroud.
    G10264172Courtesy of SUBARU OF AMERICA, INC.
  10. Disconnect the connector (A) and connector (B) from the radiator fan harness.
    G10264173Courtesy of SUBARU OF AMERICA, INC.
    G10264174Courtesy of SUBARU OF AMERICA, INC.
  11. Lower the vehicle.
  12. Remove the reservoir tank. Ref. to COOLING (H6DO)>Reservoir Tank>REMOVAL .
  13. Disconnect the radiator inlet hose LH and RH.
    G10264175Courtesy of SUBARU OF AMERICA, INC.
  14. Remove the radiator upper bracket LH and RH.
    G10264176Courtesy of SUBARU OF AMERICA, INC.
  15. Using the ST, remove the bolts securing the condenser lower bracket to the radiator.

    ST 73099SG000 SPECIAL TOOL CONDENSER 

    G10263016Courtesy of SUBARU OF AMERICA, INC.
  16. Remove the bolts securing the condenser bracket, and remove the condenser lower bracket.
    NOTE: This procedure is required to prevent the lower gasket from being damaged when removing the radiator.
    G10263017Courtesy of SUBARU OF AMERICA, INC.
  17. Remove the bolts securing the condenser upper bracket to the radiator.
    G10264179Courtesy of SUBARU OF AMERICA, INC.
  18. Secure the condenser to the vehicle using ropes or other means.
    NOTE: This procedure is required to prevent the condenser from dropping off and also the air conditioner pipes from being damaged.
    G10264180Courtesy of SUBARU OF AMERICA, INC.
  19. Remove the radiator from vehicle.
  20. Remove the radiator lower cushion from the vehicle body.
    G10263020Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals