Rear Disc Brake Assembly: Assembly
NOTE:
If the brake hose is disconnected, air enters inside. Therefore, this operation should be performed on the vehicle without the brake hose disconnected.
- Check each part. Ref. to BRAKE>Rear Disc Brake Assembly>INSPECTION .
- Install the bushing.
- Apply a coat of grease to the inside of the new piston boot.
Preparation items:
Grease: Nippon Grease NIGLUBE RX-2 or equivalent
- Using the ST, install the piston boot.
Preparation tool:
ST: PISTON BOOT INSTALLER (99099AL000)