DTC P0441: EVAP System (CPC) Incorrect Purge Flow: Notes

DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

Trouble symptom:

Improper idling

CAUTION: After servicing or replacing faulty parts, perform Clear Memory Mode Ref. to ENGINE (DIAGNOSTICS) H4DO)>CLEAR MEMORY MODE>OPERATION ., and inspection mode Ref. to ENGINE (DIAGNOSTICS) (H4DO)>INSPECTION MODE>PROCEDURE .

CHECK DTC .
Read the engine DTC using the Subaru Select Monitor or general scan tool. Ref. to ENGINE (DIAGNOSTICS) (H4DO)>READ DIAGNOSTIC TROUBLE CODE (DTC) .

Is other than DTC P0441 displayed? (Current malfunction)

Yes: Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .

No: Go to 2 .
CHECK PURGE CONTROL SOLENOID VALVE .
Operate the purge control solenoid valve using the Subaru Select Monitor.

NOTE: For detailed operation procedures, refer to the "Active Test". Ref. to ENGINE (DIAGNOSTICS) (H4DO)>ACTIVE TEST .

Does the purge control solenoid valve operate?

Yes: Go to 3 .

No: Replace the purge control solenoid valve. Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO)>PURGE CONTROL SOLENOID VALVE .
CHECK EVAPORATIVE EMISSION CONTROL SYSTEM LINE .
Turn the ignition switch to OFF.

Are there holes, cracks, clogging, or disconnection, misconception of hoses or pipes in evaporative emission control system?

Yes: Repair or replace the hoses or pipes.

No: Repair the poor contact of ECM connector.