Basic Diagnostic Procedure: Procedure
- PERFORM CUSTOMER INTERVIEW.
Using the Check List for Interview, ask the customer the condition of how the trouble occurred.
Did you interview the customer?
Yes Go to 2 .
No Interview the customer. Ref. to POWER SEAT MEMORY SYSTEM (DIAGNOSTICS)>Check List for Interview>CHECK .
- CHECK LAN SYSTEM.
Inspect LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
Is the check result OK?
Yes Go to 3 .
No Perform the inspection according to the diagnosis for LAN system.
- CHECK POWER SEAT MEMORY SYSTEM.
Using the Subaru Select Monitor, read DTC of power seat memory system. Ref. to POWER SEAT MEMORY SYSTEM (DIAGNOSTICS)>Read Diagnostic Trouble Code (DTC)>OPERATION .
Are any DTCs displayed?
Yes Perform the diagnosis for the displayed DTCs. Ref. to POWER SEAT MEMORY SYSTEM (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC)>LIST .
After the repair, Go to 5 .
No Go to 4 .
- CHECK THE LIST OF TROUBLE SYMPTOMS.
Check "TROUBLE SYMPTOM" for the power seat system. Ref. to SEATS>POWER SEAT SYSTEM>INSPECTION>TROUBLE SYMPTOM.
Does the symptom apply?
Yes Perform the diagnosis according to the inspection procedures.
No Currently, system is normal. The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause. - PERFORM INSPECTION MODE.
Perform the Inspection Mode. Ref. to POWER SEAT MEMORY SYSTEM (DIAGNOSTICS)>Inspection Mode .
Are any DTCs displayed?
Yes Perform the diagnosis for the displayed DTCs. Ref. to POWER SEAT MEMORY SYSTEM (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC)>LIST .
No Finish the diagnosis.