DTC B1576: EGI Control Module EEPROM

DIAGNOSIS START CONDITION:

Battery voltage is 10 V or more.
The remote engine starter was not used to start the engine.

DTC DETECTING CONDITION:

ECM malfunctioning
Failed to access ROM in ECM during key registration.

TROUBLE SYMPTOM:

Engine will not start.
The security indicator illuminates.

CAUTION: When the ECM is replaced, registration of the immobilizer system is required. For details, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.

PERFORM ECM REGISTRATION .
Perform ECM registration. Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.

Is registration complete?

Yes: Finish the diagnosis.

No: Go to 2 .
PERFORM ECM REGISTRATION .
Perform ECM registration. Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.

Is registration complete?

Yes: Finish the diagnosis.

No: Go to 3 .
PERFORM ECM REGISTRATION .
Perform ECM registration. Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume.

Is registration complete?

Yes: Finish the diagnosis.

No: Refer to "Correspondence table when registration is not possible" in the "REGISTRATION MANUAL FOR IMMOBILIZER" provided as a separate volume. If the registration still does not work properly, replace the ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>ENGINE CONTROL MODULE (ECM) . Ref. to FUEL INJECTION (FUEL SYSTEMS) (H6DO)>ENGINE CONTROL MODULE (ECM) .