LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> Forester Base >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Combination Meter System >> Operation >> Variant Work

Variant Work

Perform when replacing the combination meter assembly.

CAUTION:
  • Subaru Select Monitor is required for variant work.
  • If an error is displayed during the work, click the [OK] button and perform the variant work again.
  • When odometer value reading is performed, the odometer displays "--" and continued use of the combination meter assembly is impossible.
  • When the odometer writing operation is completed correctly, the odometer value is automatically cleared from the Subaru Select Monitor.

OPERATION PROCEDURE A 

  1. Read and store the ECM setting information.
    1. Connect the Subaru Select Monitor.
    2. On [Start] screen, select [Diagnosis].
    3. On [Select Vehicle] screen, enter vehicle information and select [OK].
    4. On [Main Menu] screen, select [Each System].
    5. On [Select System] screen, select [Combination Meter], and then select [Next].
    6. On [Select Function] screen, select [Work Support], and then select [Read Control module setting information].
    7. According to the display screen, save and close the file.
  2. Read the odometer value.
    NOTE: Perform the same operation procedures as those of Reading and storing the ECM setting information.
    1. On [Select Function] screen, select [Work Support], and then select [Reading and Writing of the ECU Configuration Information and Odometer Value].
    2. Perform the operation according to the display screen.
  3. Replace the combination meter assembly with a new part.
  4. Write the odometer value.
    1. Perform the operation according to the display screen.
  5. Write the ECM setting information.
    NOTE: Perform the same operation procedures as those of Reading and storing the ECM setting information.
    1. On [Select Function] screen, select [Work Support], and then select [Write Control module setting information].
    2. On the item list, select [Write ECU setting save data].
    3. Perform the operation according to the display screen.
    4. When [Write operation was completed.] is displayed, select the [OK] button.
  6. Check if the combination meter assembly operates normally.

OPERATION PROCEDURE B 

  1. Replace the combination meter assembly with a new part.
  2. Write the vehicle data.
    1. Connect the Subaru Select Monitor.
    2. On [Start] screen, select [Diagnosis].
    3. On [Vehicle selection] screen, enter vehicle information and select [OK].
    4. On [Main Menu] screen, select [Each System].
    5. On [Select System] screen, select [Combination Meter], and then select [Next].
    6. On [Select Function] screen, select [Work Support], and then select [Write Control module setting information].
    7. From the item list, select [Write ECU setting 12 columns of models]. Enter the applied model and click the [OK] button. Ref. to IDENTIFICATION>IDENTIFICATION NUMBER & LABEL LOCATIONS .
    8. Enter the option code and click the [OK] button. Ref. to IDENTIFICATION>IDENTIFICATION NUMBER & LABEL LOCATIONS .
    9. Confirm the vehicle information on [Write ECU setting 12 columns of models] screen, and click the [OK] button.
    10. When [Write?] is displayed, select the [Yes] button.
    11. Confirm that [Write operation is complete.] is displayed, and click the [OK] button.
  3. Check if the combination meter assembly operates normally.
scientia non olet · About LEMON Manuals