Basic Diagnostic Procedure: Procedure

Ask the customer when and how the trouble occurred using the interview checklist.

Did you interview the customer?

Yes  : Go to  2 .

No  : Perform the interview, and & Go to  2 .

Perform basic inspection. Ref. to POWER SEAT MEMORY (DIAGNOSTICS)>GENERAL DESCRIPTION>INSPECTION .

Is the check result OK?

Yes  : Go to  3 .

No  : Repair the faulty part found in basic inspection, and Go to  3 .

1. Turn the ignition switch to OFF.
2. Connect the Subaru Select Monitor to data link connector. Ref. to COMMON (DIAG)>DATA LINK CONNECTOR .
3. Turn the ignition switch to ON and run the Subaru Select Monitor.
4. Select [Power Seat Memory].
   NOTE: For detailed operation procedures, refer to "Help" of application.

Is communication possible?

Yes  : Go to  4 .

No  : Check the communication circuit. Ref. to POWER SEAT MEMORY (DIAGNOSTICS) DIAGNOSTIC PROCEDURE FOR SUBARU SELECT MONITOR COMMUNICATION .

Read the DTC of [Power Seat Memory] using the Subaru Select Monitor, Ref. to POWER SEAT MEMORY (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

Are any DTCs displayed? (Current malfunction)

Yes  : Record the DTC, time stamp and freeze frame data, and go to next, Go to  5 .

No  : Perform diagnosis according to the procedures in the diagnostics with phenomenon. Ref. to POWER SEAT MEMORY (DIAGNOSTICS) DIAGNOSTICS WITH PHENOMENON .

1. Perform the diagnosis for the displayed DTCs. Ref. to POWER SEAT MEMORY (DIAGNOSTICS) DIAGNOSTIC TROUBLE CODE (DTC)>LIST .
2. Repair or replace the cause of trouble.
3. Using the Subaru Select Monitor, perform the clear memory of [Power Seat Memory]. Ref. to COMMON(DIAG)>CLEAR MEMORY .
4. Execute the inspection mode. Ref. to POWER SEAT MEMORY (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .
5. Read the DTC of [Power Seat Memory] using the Subaru Select Monitor. Ref. to POWER SEAT MEMORY (DIAGNOSTICS)DIAGNOSTIC TROUBLE CODE (DTC) .

Are any DTCs displayed? (Current malfunction)

Yes  : Repeat step 5 until DTC is not shown.

No  : Finish the diagnosis.