Active Test: List

Active test items

Contents

Execution condition

Fuel Pump Relay

ON/OFF of the fuel pump can be set.

Ignition switch ON (engine OFF)

CPC Solenoid Valve

ON/OFF of the purge control solenoid valve can be set.

Radiator Fan Relay

ON/OFF of the radiator fan relay can be set.

ELCM switching valve

ON/OFF of the leak check valve assembly switching valve can be set.

ELCM pump

ON/OFF of the leak check valve assembly vacuum pump can be set.

Fuel Pump Control (OFF Drive)

Fuel pump can be set to OFF.

Non-load idling⁽¹⁾

Fixed Idle Ignition Timing

Ignition timing is set to 6° - 18° according to engine speed.

Idle Speed Control

Idle speed can be set to 1000 - 2000 rpm.

CAUTION: Idle speed can be set up to 500 rpm at the Subaru Select Monitor. However, do not set to 1000 rpm or less.

Injection Stop Mode (Injector 1) Injection Stop Mode (Injector 2) Injection Stop Mode (Injector 3) Injection Stop Mode (Injector 4)

Injector of each cylinder can be set to stop the fuel injection.

Injection Quantity Control

The amount of fuel injection can be set to -13 - 20%.

EGR Valve Control (Step)

EGR control valve can be set to 0 - 68 STEP.

Active Grille Shutter Control⁽²⁾

Open ←→ close of the active grille shutter can be set.

Ignition switch ON (engine OFF)
Experienced 20 seconds or more of the elapsed time after starting engine (when replacing ECM)

Electric Vent Solenoid Value

Open/close status of the valve that seals the fuel tank is displayed.
Open: Not sealed
Close: Sealed

Fuel Filler Lid Lock Solenoid Relay Output

Operating status of the relay that drives the lock assembly fuel is displayed.
ON: Opens the fuel lid
OFF: Does not open the lock assembly fuel

⁽¹⁾

A condition where Inspection Mode for measuring Exhaust Gas is initiated before starting engine and the following data monitor items are ON after starting engine corresponds to non-load idling. Refer to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>Work Support>OPERATION>SERVICE MODE . Refer to ENGINE (DIAGNOSTICS) (H4DO (HEV))>DATA MONITOR .

Service mode
Engine self-sustaining judgment

⁽²⁾	After replacing ECM or active grille shutter, be sure to perform this procedure.