IMPREZA Model
CAUTION:
- For parts which are not reusable, always use new parts.
- Do not apply grease to the tapered portion of ball stud.
- Make sure that there is no gap between the front axle housing and the collar.
- If the collar comes off from the front axle housing, replace the front axle housing with a new part.
- Install the ball joint to the front axle housing.
Tightening torque:
51 N.m (5.2 kgf-m, 37.6 ft-lb)
- Insert the washer, and secure the flange nut.
- Insert a new snap pin.
- Install the drive shaft.
Refer to DRIVE SHAFT SYSTEM>FRONT DRIVE SHAFT>INSTALLATION .
- Install the flange nut on the bottom of the ball joint.
Tightening torque:
100 N.m (10.2 kgf-m, 73.8 ft-lb)
- Install the stabilizer link (bottom part).
Tightening torque:
60 N.m (6.1 kgf-m, 44.3 ft-lb)
- Install the tie-rod end.NOTE:
- Do not forget to install the washer.
- When tightening the castle nut, tighten the castle nut to the specified torque first, then tighten it further but within 60° until the hole in the ball stud is aligned with a slot in castle nut.
Tightening torque:
27 N.m (2.7 kgf-m, 19.9 ft-lb)
- Insert a new cotter pin and secure the castle nut.
- Install the crossmember support - rear.
Tightening torque:
70 N.m (7.1 kgf-m, 51.6 ft-lb)
- Install the under cover - front.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Lower the vehicle, and install the front wheels.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)
- Confirm that the wheels are in full contact with the ground, and tighten the nuts of the strut mount CTR.CAUTION: Be sure to use a new self-locking nut.
Tightening torque:
55 N.m (5.6 kgf-m, 40.6 ft-lb)