Inspection Mode 1
WARNING: This page is about a different variant/trim than selected.
| Code | Note | Number of driving cycles on the detecting condition |
|---|---|---|
| P060649 | - | 1 |
| P060B49 | - | 1 |
| P0D5615 | - | 1 |
| P062F44 | - | 1 |
Diagnostic procedure:
- Using the Subaru Select Monitor, perform the clear memory of [Plug-in Battery Charger]. Refer to COMMON (DIAG)>CLEAR MEMORY .
- Turn IG OFF and wait for 2 minutes or more.
- Using the Subaru Select Monitor, read the DTC of [Plug-in Battery Charger] to check that there is no DTC displayed. Refer to PLUG-IN BATTERY CHARGER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1).
- Turn IG ON and wait for 5 seconds or more.
- Read the [Readiness code] of [Plug-in Battery Charger] using Subaru Select Monitor and check that the concerned self-diagnosis is completed. Refer to PLUG-IN BATTERY CHARGER (DIAGNOSTICS)>ALL READINESS DIAGNOSTIC CODE(S) .NOTE: If the concerned DTC is displayed, the self-diagnosis of the DTC is not complete. Repeat from step 4).
- Using the Subaru Select Monitor, read the DTC of [Plug-in Battery Charger] to check that there is no DTC displayed. Refer to PLUG-IN BATTERY CHARGER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.