How To Use General Scan Tool
WARNING: This page is about a different variant/trim than selected.
- Prepare a scan tool (general scan tool) required by SAE J1978.
- Connect the general scan tool to data link connector located in the lower portion of the instrument panel (on the driver's side). Refer to COMMON (DIAG)>DATA LINK CONNECTOR .
- Using the general scan tool, call up each data. General scan tool functions consist of:
- MODE $01: Current powertrain diagnostic data
- MODE $02: Freeze frame data
- MODE $ 03: Emission-related DTC
- MODE $04: Clear/Reset emission-related diagnostic information
- MODE $07: Request on-board monitoring test results for intermittently monitored systems
- MODE $09: Request vehicle information
- MODE $0A: Emission-related DTC (with Permanent Status)
- Read data according to the repair procedure. (For detailed operation procedures, refer to the general scan tool operation instructions.)NOTE: For details concerning DTC, refer to "Diagnostic Trouble Code (DTC)". Refer to PLUG-IN BATTERY CHARGER (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .