LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Cooling System (HEV)) >> Active Grille Shutter >> Installation

Active Grille Shutter: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the ambient sensor.
  2. Install the active grille shutter.

    Tightening torque: 

    7.5 N.m (0.8 gf-m, 5.5 ft-lb)

  3. Connect the connector to the active grille shutter actuator.
  4. Connect the connector to the ambient sensor.
  5. Install the front bumper.

    Refer to EXTERIOR/INTERIOR TRIM>FRONT BUMPER>INSTALLATION .

  6. Connect the battery ground terminal.

    Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .

  7. When the active grille shutter has been replaced, perform the calibration (execute the system operation check for ACTGS control).

    Refer to ENGINE (DIAGNOSTICS) (H4DO (HEV))>ACTIVE TEST .

scientia non olet · About LEMON Manuals