Adjustment Value Clear

WARNING: This page is about a different car, the 2019 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)

On the work support item list, select [Clear adjustment value].
When [Make the following adjustment/inspection. Please push OK if ready. CAUTION! - Please confirm because the chart position height differs according to the model (vehicle height). - Set the ignition switch to OFF after press Cancel at the end of adjustment/inspection mode.] is displayed, select [OK] if preparation is ready.
After [Clear the adjustment value. CAUTION! Perform this only under the conditions listed in the service manual.] is displayed, select [OK].
When [Clearing adjustment value...] is displayed, wait until it finishes.
When the adjustment value clear operation is finished correctly, [Adjustment value clear OK! Adjustment value clear is completed. Please to IG OFF more than 5 seconds. (CODE & BYTE03)] is displayed. Select [OK] to finish.
Turn the ignition switch to OFF and wait for approx. 5 seconds or more.
CAUTION: If the ignition switch OFF period is short, the adjustment value clear operation can not be performed correctly.
Next, perform the camera all adjustment mode (replacement/removal). Ref. to EYESIGHT>CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL) .